how to get ipmi mac address from linux command line

No.#4 Set timezone on nutanix running cluster Want to know nutanix cluster and running services status, Issue following command from any CVM cvm$ cluster status No.#3 Show cluster status and running services Production To Start Nutanix cluster following commandĬvm$ cluster start To Stop Nutanix cluster following command Stop the nutanix cluster for sometime and start again to begin

Use –redundancy_factor 3 need atleast 5 nodes for build the nutanixĬluster, RF-3 keeps two additional copy of master data, if two nodesįor any hardware maintenance or relocation of the nutanix nodes need to Goes down or in maintenance mode no impact on nutanix cluster Use –redundancy_factor 2 need at least 3 nodes for build the nutanixĬluster, RF-2 keeps one additional copy of master data, if one nodes Note: –redundancy_factor parameter has to values 2 and 3 OR can do same thing to add extra prefix parameters in above command cvm$> cluster –cluster_name= -cluster_external_ip= -dns_servers= -ntp_servers= -redundancy_factor=2 -s cvm1_IP_addr,cvm2_IP_addr,cvm3_IP_addr, So on. Note: Each CVM IP adddress separeted by comma (,) without space Issue following commands of any controller VM (CVM) cvm$> cluster -s cvm1_ip_addr,cvm2_ip_addr,cvm3_ip_addr create Make sure that all the CVMs, Nodes and IPMI IP addresses are reachable or ping able to each other. If you are planning to create new Nutanix cluster required at least three nodes for RF-2 cluster If you provide incorrect password, the command would fail with the error message “ Logon failure: unknown user name or bad password.No.#1 Build a new Nutanix cluster with at least 3 nodes

If you try this for a Linux machine you would get the error “ The RPC server is unavailable.” Using getmac command we can retrieve the mac addresses of the machines running windows OS only. You will be prompted to enter the password and the command execution will take place after that. If you do not want to specify the password, you can skip /p parameter. Just run the command getmac to get the mac addresses. It works on XP, Vista, Windows 7, Server 2003 and Server 2008 operating systems. Below are few examples on how to use this command. This can be used to get mac address for remote computers also. We can find mac address (physical address) of a computer using the command ‘ getmac‘.

How to get ipmi mac address from linux command line